Lane Control Systems

Center Information page and FAQ's with Tips

Get your system on line. With the Lane Control Card (LCC)

The Links on this page for the lane control program will have all your activation stuff in the configuration file,

As soon as you install the lane control all should work, providing no changes have been made to the initial setup on the Lane Control Card,

Lane control card should be set at the following unless problems were encountered

Default setup is     Com port 2e8

Default           IRQ is 3

Run your configuration program and make sure all information matches your information, such as, scorer type, Com Port 4 ( com4 ) enter it in if not there

If Lane Control software is scrambled or is not legible install ansi.sys.

After the ansi.sys is installed restart your computer, so that the ansi.sys file will load, correctly,

Ansi.Sys should be installed in the Config file of your computer

If you use the lane control install program it will automatically install the Ansi program

Trouble shooting Lane Control Card

Leds flashing,

Step 1

Flashing red and green means your software is not communicating with the card, check com port setting on board and in software make sure they match, also check Irq on board and in software to make sure they match

Step 2.

Flashing leds - green solid, red flashing just a tickle, no yellow lite flashing, you do not have comms with the scorers, via receive to the board, in computer, check that interface plug is in all the way on the back of the card, check plug interface from crossover cable to the existing scoring network wires is connected, if all of the above is met you should have comms.

Step 3

Flashing leds - no comms  but everything in step 2 is correct or good then, Check software scorer selection in software setup, make sure it is set for your type scoring and your exact version of firmware, should be marked on your scoring board on the eproms with tags, Read the version  numbers on them.

Step 4

If software gives you errors when you try to start the program you must reinstall the software, set up your configuration file and all should work accordingly.

Links below work if you have a front desk lane control card,  If you do not have a link to a control program, it is because you do not have the new front desk card  in place, however your center is eligible compatible because of the work we have done in it. Some links are old links to the old system if you have not updated to the new card.

Sky Lane  MN Config Program

Sky Lanes  ND Config Program

Ten Spot Lanes ND Config Program

Town & Country MT Config Program

Our Place Lanes ND Config Program

Capitol Lanes ND Config Program

Country Lanes Mt Config Program

Nokomis Lanes MN Config Program

Midway Pro Bowl MN Config Program

Eltoro Lanes MN Config Program

North Hill Bowl ND Config Program

Stremmick Lanes ND Config Program

Wonder Lanes ND Config Program

All Star Bowl ND Config Program

Tri County Lanes ND Config Program

Ashley Lanes ND Config Program

Imperial Lanes ND Config Program

Crosby Lanes ND Config Program

Hit Or Miss Lanes ND Config Program

Columbian Lanes ND Config Program

Paragon Bowl ND Config Program

Classic Lanes ND Config Program

Crown Lanes ND Config Program

If your center does not have a link, we have not had time to upload all the technical data for your center, Please be patient as we progress with the Online help.